Maintenance and protection of deburring machine:
The maintenance of the deburring machine in addition to the end of each use, the water and workpiece residue on the working table of the deburring machine should be cleaned. If the dust on the printed circuit board is not removed, it will simply absorb the water and corrosive things in the air for a long time, corroding the originally fine conductive copper skin, causing problems with the machine tool. It is also necessary to often organize the dust inside the electrical box, such as the dust on the power resistance, the dust on the bridge pile, especially the dust on the printed circuit board, which is conducive to the heat dissipation effect of the electrical components.
The protection and maintenance of the rotary head of the deburring machine manufacturer is similar to the water pump of the deburring machine. The rotary head is also operated under high pressure, and his seals need to be replaced regularly. If it is replaced when there is water leakage, it is possible that the water has penetrated into the bearing, and the loss is greater. CNC EDM perforating machine pump maintenance, deburring machine pump is operating under 6Mpa operating pressure, the crankshaft is under very large pressure, if the lubricating oil after a period of time after the operation is not immediately replaced, it will cause very serious consequences. This is a lot of deburring machine users are simply ignored, we should pay attention to. Since the water pump is a very important part in the deburring machine, if there is a problem with this part, it will affect the use of the whole machine tool.
